Air spa blower troubleshooting starts with working through a blower issue on an Advantage™ Air Spa system, step by step. If these steps don’t resolve it, contact technical support at 877-234-2284.
| Problem | Possible Cause / Question / Action | Corrective Action / Solution |
|---|---|---|
| Blower not working | Check GFCI/power to the tub | Reset GFCI/supply 13 amps of power |
| Blower still not working | Unplug blower from the controller and plug it into the power source | If the blower runs, then troubleshoot the controller and key pad. |
| Blower still not working | Did the blower get wet? | Let the blower dry and try again. If dry, replace blower. |
| If the blower runs for a few minutes, then stops | The blower may have overheated and shut itself off | Let the blower cool for 30 minutes and clean any clogged jets. |
| Check the controller | Plug the known good blower back into the controller. Unplug the key pad from the controller. | |
| Jumper the red and green wires on the controller connector. | If the blower runs, replace the keypad. If the blower does not run, replace the controller. |